A place for all things Radio Controlled
 
HomeFAQSearchRegisterLog in
Come sign up on the new forum ----- www.myrcguide.com

Share | 
 

 Rotation hub assembly -noob how to needed!

View previous topic View next topic Go down 
AuthorMessage
Pittnuma

avatar


PostSubject: Rotation hub assembly -noob how to needed!   Thu Aug 20, 2009 7:24 pm

Hi all,

Can somebody tell me how I change a rotation hub assembly? More to the point how do I take it off?

I have the main blades off but cannot figure out how to take the ub assembly off.


This is on a Venom Night Ranger 2 (I now know why it was soo cheap!!)
1 careful owner my censored


However it is teaching me about stripping a heli!
Pitt
Back to top Go down
247rememberme

avatar


PostSubject: Re: Rotation hub assembly -noob how to needed!   Fri Aug 21, 2009 3:44 pm

i`d love to help but i`ve just got my `Bee`.
the "1 careful owner my censored "did make me laugh tho` orange80
Back to top Go down
Pittnuma

avatar


PostSubject: Re: Rotation hub assembly -noob how to needed!   Fri Aug 21, 2009 3:55 pm

No worries, Iordered the new hub assembly yesterday, should be here tomorrow, just need to get the original off. Take it a sledge hammer is a bit of an overkill? orange6

1 week to go and I'm ordering my Bee & CP (CP is at $155 through August, seems a good price).

Pitt

like the signature orange68
Back to top Go down
247rememberme

avatar


PostSubject: Re: Rotation hub assembly -noob how to needed!   Fri Aug 21, 2009 4:44 pm

Pittnuma wrote:
Take it a sledge hammer is a bit of an overkill?
the amount of times i`ve thought that :hahaha:
Back to top Go down
Pittnuma

avatar


PostSubject: Re: Rotation hub assembly -noob how to needed!   Fri Aug 21, 2009 5:41 pm

Done it :hahaha:

Trick will be putting it all together again the right way!!! Crazysmile


Pitt
Back to top Go down
247rememberme

avatar


PostSubject: Re: Rotation hub assembly -noob how to needed!   Fri Aug 21, 2009 6:02 pm

first time i changed a servo i thought it`d be easy so i didn`t bother paying much attention to how it was placed orange1
tried placing the new servo in the same place and holy s censored t it wouldn`t fit headbeat
took me AGES to figure it out,wish i`d paid more attention orange44
Back to top Go down
Sponsored content




PostSubject: Re: Rotation hub assembly -noob how to needed!   

Back to top Go down
 
Rotation hub assembly -noob how to needed!
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» re up needed for METROMEDIA V SUPERDEE 88
» 1992.01.03 - LSU Assembly Center, Baton Rouge, USA
» Band info needed: "Torque"
» Prayers needed!

Permissions in this forum:You cannot reply to topics in this forum
RC Guides Forums :: RC Helicopters :: 4ch FP and Co-Axial Helicopters-
Jump to: