A place for all things Radio Controlled
 
HomeFAQSearchRegisterLog in
Come sign up on the new forum ----- www.myrcguide.com

Share | 
 

 380X motor w/ stock blade

View previous topic View next topic Go down 
AuthorMessage
pinguin6218

avatar


PostSubject: 380X motor w/ stock blade   Wed Sep 30, 2009 8:36 am

Anybody using 380x motor with stock motor? How is it? I heard it will fry the 4in1
Back to top Go down
jstarks

avatar


PostSubject: Re: 380X motor w/ stock blade   Wed Sep 30, 2009 9:06 am

I have a 380x motor that will be here friday, to put on my hbfp.

I talked (e-mailed) to the tech dept at xtreme about wether or not it would fry the 4in1 like I had heard. They said that the stock blades have too much drag and load up the motor too much and that is why some people have fried the 4in1. They also told me that the set up that they recomend is 380x motor with either xtreme 8degree pitch wooden or xtreme plastic blades and everything will be fine.

I asked if I needed to install a fuse between the 4in1 and the motor and thay said if I use the combination above, it wont be neccesary but if I absolutely wanted to they recomend using a 10 amp fuse.

Here is the site that I went to and asked the questions.

I did put a set of 10 degre pitch wooden blades on it with the stock motor and it's amazing to me how much better it flys. orange74

Hope this helps!

J.
Back to top Go down
pinguin6218

avatar


PostSubject: Re: 380X motor w/ stock blade   Wed Sep 30, 2009 9:54 am

So it's confirm that the stock blade cannot be use with 380X motor.

Here what I got from other forum
Back to top Go down
Mozzy

avatar


PostSubject: Re: 380X motor w/ stock blade   Wed Sep 30, 2009 5:11 pm

Better be on the save side and use a 7.5 Amp fuse.
The 4in1 is reported to burn out at 8 Amps.

I have been flying with the 380 Xtreme motor with a 7,5 Amp fuse and Xtreme fiber blades for some time. I even used a 3S lipo, but than in mid air the fuse blew one in a while for no reason.
Back to top Go down
Sponsored content




PostSubject: Re: 380X motor w/ stock blade   

Back to top Go down
 
380X motor w/ stock blade
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Brian Blade Blue Note
» Brian Blade singing
» Do you seal your blade?
» Vinnie Touring Again with Jeff Beck
» Youtube video of a recent gig

Permissions in this forum:You cannot reply to topics in this forum
RC Guides Forums :: RC Helicopters :: 4ch FP and Co-Axial Helicopters-
Jump to: