A place for all things Radio Controlled
HomeFAQSearchRegisterLog in
Come sign up on the new forum ----- www.myrcguide.com

Share | 

 What's causing this?

Go down 

PostSubject: What's causing this?   Mon Oct 19, 2009 12:00 pm

When hovering tail-in, I can see that my HBFP V2 is slightly tilted to the right. The swashplate is level after initializing. Based on the vid if the swashplate is tilted to the right, then this may happen but mine's level. So, any idea what's causing this?
Back to top Go down


PostSubject: try this   Mon Oct 19, 2009 12:12 pm

take 2 pencils, turn you fly bar facing front to back. Place pencils under fly bar and look at heli. See if it leans to the right. It might be heavier on that side.
Back to top Go down
Frankie G

PostSubject: Re: What's causing this?   Mon Oct 19, 2009 12:56 pm

Keep in mind that if after you test the heli's balance on the pencils that if you still see it leaning when it hover then it's probably normal. Your tail is pushing air to the side to keep the heli straight and if the heli was perfectly level then it would drift. The lean is the effect of counter acting this. They all do it.
Back to top Go down

PostSubject: Re: What's causing this?   Mon Oct 19, 2009 7:50 pm

Think there's no cause for concerns then.. The pencils test shows its level. Tks..
Back to top Go down

PostSubject: Re: What's causing this?   Mon Oct 19, 2009 8:05 pm

mine does the same thing, it always has a bit of a tilt to it, no need to be concerned unless the heli is shooting off in some strange direction

I'm not ignoring anyone, I'm just really busy and forgetful.
Back to top Go down
Sponsored content

PostSubject: Re: What's causing this?   

Back to top Go down
What's causing this?
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
RC Guides Forums :: RC Helicopters :: 4ch FP and Co-Axial Helicopters-
Jump to: