A place for all things Radio Controlled
HomeFAQSearchRegisterLog in
Come sign up on the new forum ----- www.myrcguide.com

Share | 

 Detrum GY48V gyro tail wag

Go down 


PostSubject: Detrum GY48V gyro tail wag   Thu Oct 29, 2009 1:57 am

Hi All
I have just installed a Detrum GY48V Heading hold gyro onto my Esky Belt CP...The helicopter now has a pretty bad tail wag and is unflyable.

Neither the gyro or my radio, (Spektrum DX6) has Heading Hold adjustment and so does anyone have any suggestions as to how I might be able to remove the tail wag?

Any assistance greatly appreciated.

Back to top Go down


PostSubject: Re: Detrum GY48V gyro tail wag   Thu Oct 29, 2009 2:17 am

if your heli dosnt spin like crazy, then your gain is too high. lower it down and start abouit 75 %. lower it till you dont get a tail wag...
Back to top Go down


PostSubject: Re: Detrum GY48V gyro tail wag   Thu Oct 29, 2009 3:59 am

Have you tried the DELAY dial on the gyro? This should do the trick.
I use this gyro with a digital servo with delay set to zero. The tail is rock solid :bigthumb:
(Do not set delay to zero when using an analog servo as you risk burning the servo)

Is the LED burning solid when the gyro is initiated (indicating Heading Hold mode)?

I use a Spektrum DX6i, don't know about the DX6. I guess your gyro-channel (5?) is represented by a switch on the Tx? Can't you use END POINTS to adjust the maximum and minimum values of this channel?
Back to top Go down
Sponsored content

PostSubject: Re: Detrum GY48V gyro tail wag   

Back to top Go down
Detrum GY48V gyro tail wag
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
RC Guides Forums :: RC Helicopters :: 6ch Collective Pitch Helicopters-
Jump to: