So I finally got a kit to swap over my parts. I ended up getting the EXI 450 Plastic Version 2:
http://www.xheli.com/exi450arfrar.htmlI've started to put it together and plan to use all of my electronics from the ESKY Belt CP V2. I've run into a few issue so far:
1) What screws do you use to mount the servers to the frame? The screws from the belt CP were too small for the EXI frame, and I didn't find anything that would work with the parts the EXI came with. Nuttcase, I saw in your video that you had servo screws with nuts on the back. I don't have any of those, where can I get something like that?
2) Motor - It doesn't look like the shaft is long enough on the stock Belt CP motor for the pinion to reach the gear on the EXI. Did others run into this issue? Do I have to buy a new motor?
3) Servos - The Belt CP used 2 servos to control the back half of the swash and 1 up front. The EXI seems to use 2 servos up front and only 1 in the back. Which is the exact opposite. Do I need to do anything special to accommodate this on the RX/TX?
Thanks so much everyone! This is the first kit I've ever attempted to build, so any help would be greatly appreciated!
-Keith