Subject: Dx6i Bind/Rebind ? Sat Jul 04, 2009 5:15 pm
Hi All, Quick question. Just switched over to the Dx6i which is new for me coming from a Futaba 7cap. After the basic setup, heli name, throttle down, cyclic middle position I bound the Rx. Then I set up everthing else for the EXI 450 with the pitch curves, endpoints, subtrim etc..but never rebound the Rx and I don't seem to have any problems. Question is do I have to rebind the Rx? Thanks in advance. George
Fatdaddy
Subject: OK Sat Jul 04, 2009 9:00 pm
No you should be ok!!! You don't need to do anything else...
GW
Subject: Re: Dx6i Bind/Rebind ? Sun Jul 05, 2009 8:35 am
Thanks for clearing this up. Wasn't sure if it was necessary. Manual said to rebind so that the radio knows the fail safe but since I started out with low throttle stick and cyclic in center when I did the bind, I didn't see a reason to rebind again. Most of the Youtube video's show how to bind but never say anything more about a rebind after everything is setup. George
Fatdaddy
Subject: ??? Sun Jul 05, 2009 8:50 am
Well George, It would not hurt to bind it again and it is simple enough to do!!! GOOD LUCK!!
Subject: Dx6i Bind/Rebind ? 
Sat Jul 04, 2009 5:15 pm
