belt cp V2 help

Hi guys. I just had the same problem with the ESC on my best CP V2 that everyone has had. So I upgraded it to a 30A Exceed Volcano series, but the wires that connect the ESC to the motor are bigger than the wires on the stock ESC. So I was wondering where I can buy some adapter fitting to connect the two different size wires, or how I should get around this problem.

Thanks!!

Just cut off the wrong size and sodier up the new ones! I don't know of and adpters.

you need 3.5mm bullets on the motor to match the esc
http://www.helidirect.com/gold-bullet-banana-connector-set35mm-p-7204.hdx

the esky motors use 2mm bullets


try radio shack if you have no lhs arouund you

-pete

yes get rid of the ESky connectors and solder new connectors to the motor

I had the same problem on my Belt CP, and when I got my Exceed ESC, I cut the ones that were on the old ESC and soldered them to the Exceed ESC. I haven't had any problems out of it, but you could do it that way. You can go buy those larger ones and put them on your motor leads too. I've done it both ways in the past and never had any problems with the ESC either way.

I just cut the ones off of the Esky ESC and put them on the Exceed ESC, because it was a cheap and readily available fix for me at the time.

Best of Luck and Fly Hard and Have Fun!!!!!