Transpro exi zl head differnt (More Video)

ok xheck this out guy i can't seem to get my zero at mid stick cause i can't get this links any shorter it got it close but bot go enoungh its like 2 degrees off and i have it short as i can go to basicly that the best its ever going to get unless im going something very wrong heres the video

switch your camera to macro because its all blury and I cant see anything.......

Every web search I did shows that crazy head setup but nothing with a good
easy to see picture.

Besides how do you know that those links are the problem? Are you getting
consistant readings with full negative collective and full positive collective?

Usually you can set full + and - to your 12 degree pitch using the links
off the servos, and end up with 0 at mid.

I think you should work your way back down and try adjusting the main
links from the servos. Concentrate only on getting 12 degrees at full - collective
and full + collective. Then you will end up with 0 in the middle.

EXI kits are better than Esky kits. What a different head design. I might think
about removing the extra linkage if it was mine......

i was looking more carefully at the xheli head i showed on the website and it seems that bar i was showing u all on top seems to be in a differnt place on the exi head that same bar looks to me that its inbetween the flybar cage where mine in on top ill try to get better video im gunna put this on hold for a few hours and work on my tail servo but it seems that there is way to much throw in the servo arm can u limit the throw with Tx


right now my pitchg i feel is good enough to were i can set up my tail then see how it flys then work on the head again but u were saying u can adjust the pitch some how with just the links on the swash

yes it is important that you get the same amount of positive pitch as
negative pitch in 3D mode. this is done using the links to the servos.

When setup like this you will get 0 pitch at mid stick. Or real close and
then you can dial it in using the other links.

I start from the top down and back up. Might work for you. I start at the top
and get everything straight and even. then using the links on the servo get
your =12 and + 12 pitch in 3D mode. Then I put the collective stick at mid
setting and dial in the 0 pitch on both blades. Then make sure swash is level..

ok i see what your saying and i can do that but to only to a certain point cause the links will not go any shorter if they could go shorter this would be so easy but i would think with everything that came with this kit should be enoungh to get it the way it should im gunna make some clear videos in a few min to show all u guys eassy to see then to just read