falcon 40

can someone please tell me how to make my falcon 40 from shaking badly i can't fig out how to make it stop i crashed it last week got my new parts put it all back together and it shakes so bad you can't even get it up an inch

did you make sure the main blades are balanced?

Also make sure the flybar is equal length from the rotor head on each side

thanks man that was the problem my flybars were not equal

hey does ne 1 know if a honey bee FP tail motor will fit on my falcon 40? i found a local dealer that has hbfp tail motor does ne1 think it will fit/work it look like its the same to me

-Bryan

I'm 98% sure it'll work fine

thanks man your like my heli guru

Nuttcaze wrote:

I'm 98% sure it'll work fine

i love a man who knows his figures

i got a falcon 40 laying around and i wanna give it to my brother to mess with and i put super skids on it and never tryied flying it cause i bought a HBFP cause the falcon sucks but today i was testing to before i was gunna give it to him and it only get like 2 feet off the ground with a 7.4 li-po there a site that sell and say if u buy the 370 motor w 11tooth and a tail motor with 10 tooth tail motor you can use a 11.1 li-po on it.. this seems kinda hard to believe that just changing the count of teeth will be able to use a 11.1 one is this true ohhh plus adding fuses in between the motors


when motors start to go bad do then spin slower when at full throttle cause i put it at full and it seems that it might not be the weight of the super skids more of maybe the motor is not as powerfull ..any one every fly a falcon 40 with superskids and did it fly pretty much the say as stock?